LED display always fails to load? Six skills to teach you the perfect crack!
When using the led display, it often happens that it cannot be loaded. The reasons why the led display cannot be loaded can be analyzed from the following aspects.
1. Check whether the jumper cap is loose or fall off; if the jumper cap is not loose, please make sure the direction of the jumper cap is correct.
2. Check and confirm that the serial cable used to connect the controller is a straight-through cable, not a crossover cable.
3. Check and confirm that the serial port cable is intact and that both ends are not loose or falling off.
4. Select the correct product model, correct transmission method, correct serial port number, correct serial transmission rate according to the LED display control software and the control card you choose, and set them correctly according to the DIP switch diagram provided in the software Controls the address bits and serial transfer rate on the system hardware.
5. Make sure the control system hardware is powered on correctly.
6. If it still fails to load after the above inspection and correction, please use a multimeter to measure whether the serial port of the connected computer or control system hardware is damaged. To confirm whether it should be returned to the computer manufacturer or the control system hardware should be returned for testing.